9
Maintenance inspection / storage
Only competent persons are allowed to carry out maintenance inspection of the chain
hoist.
Failure to comply with these instructions may result in death or serious injury:
- The competent person should carry out maintenance inspection in accordance with page 17 to 39 and Disassembly/
Reassembly Manual.
- Do not cut, extend, or weld the load and hand chains.
- Do not apply oil to the braking part.
Comply with the following instructions when carrying out maintenance inspection and
storing the chain hoist.
Failure to comply with these instructions may result in injury or physical damage to property:
- To avoid misuse of the chain hoist under repair, apply a label indicating "failure/inspection in progress" on the chain hoist.
- When storing the chain hoist, wipe off dust and waterdrop, apply oil to the neck of the hook and load chain and store the hoist
indoors when not used for lifting loads.
- When replacing a part, use only an authorized part for the KITO model CX chain hoist.
Even though the part is an authorized one for KITO chain hoist, it may not be used for different model.
- Wear protection equipment such as protection goggles and gloves depending on the work contents. Especially, wear helmet
and safety belt when carrying the high lift work.
- Pay attention to work method, work procedure and work posture.
- Remove the oil or grease attached to the product or spilt on the floor.And keep the work area clean when disassembling the
product.
Mandatory
Mandatory
To Next Page
Loading...
Need help?
General
