5
CAUTION
• Do not drag or drop the product when carrying.
Otherwise it causes damage or flaw of the electric chain hoist, bodily injury or loss of property due to the drop of the
lifted load.
Prohibited
Mandatory
• When discarding the product, disassemble it not to be used and discard in accordance with the ordinances
of local government or the rules specified by the business entity.
Ask the local government or the relevant section for the details.
Refer to “Disassembly/Assembly Manual” for disassembling, or contact KITO.
(This product uses oil. We prepare MSDS (Materials Safety Data Sheet) for the oil. Contact KITO for it.)
• Carry out daily inspection by user.
• Carry out inspection (monthly, annual) by maintenance engineer.
• Keep the record of the inspection.
Failure to comply with these instructions causes bodily injury or loss of property.
■
General Matters on Handling of EQ Series Electric Chain Hoist
The EQ series electric chain hoist is controlled by VFD for important items related to safety such as operation,
braking and emergency stop. Be sure to follow the safety precautions below as well as the above safety precautions.
• Do not reassemble the EQ series electric chain hoist to contactor type.
• Do not change parameters.
When parameters need to be changed, ask distributor or KITO.
• Do not carry out the work such as maintenance and inspection within 5 minutes after power off.
Wait for the completion of discharging of the capacitor inside the VFD.
• Do not change the connection of the VFD.
When the wires were removed for any reason, connect them again correctly checking the wiring diagram inside the
controller cover.
• Do not carry out withstand voltage test and insulation resistance measurement of a circuit by megger while
the VFD is connected.
• Do not turn off the power while operating.
• Never turn off the power when a load is suspended.
Never, under any circumstances, turn off the power when a load is suspended. Doing so will cause the load to be
slightly lowered after the power is turned on again due to control system initial preparation.
Failure to comply with these instructions may result in death or serious injury and the damage of VFD.
Prohibited
DANGER
Mandatory
• USE KITO genuine VFD.
The VFD requires the special specification for KITO. Be sure to use genuine VFD.
Failure to comply with this instruction may result in death or serious injury.