KITO EQ series User Manual

87
■
Guidelines on Gear Parts Replacement (Load Gear, Friction
clutch with Gear 2, Gear 3)
Operating hours to replace parts
Body size grade
Every 800 hours Every 1600 hours Every 3200 hours
M5, 2m – Parts replacement –
M6, 3m – – Parts replacement
■
Guidelines on Motor Shaft (with Rotor) Replacement
Operating hours to replace
Body size grade
parts
Every 400 hours Every 800 hours Every 1600 hours Every 3200 hours
M5, 2m – Apply grease on spline Parts replacement –
M6, 3m – Apply grease on spline – Parts replacement
Guidelines for Parts Replacement based on Indication of CH Meter
2
(to be continued)
* Grease needs to be applied on spline part every 800, 1600 and 2400 hours.
■
Guidelines on Bearing Replacement
Operating hours to replace parts
Body size grade
Every 800 hours Every 1600 hours Every 3200 hours
M5, 2m – Parts replacement –
M6, 3m – – Parts replacement
■
Guidelines on Hook, Yoke and Suspension Eye Replacement
Replace the Hook, Yoke and Suspension Eye in accordance with the rate of loading and the number of start in the
following table.
Number of start to replace parts
Rate of loading
Every million times
Every 1.5 million
times
Every 2 million
times
Light
A case where the capacity is rarely applied. Usually the hoist is
used with a light load.
○
Medium
A case where the capacity is applied considerably frequently.
Usually the hoist is used with a medium load.
○
Heavy
A case where the capacity is applied considerably frequently.
Usually the hoist is used with a heavy load.
○
Ultra
heavy
A case where the capacity is applied constantly.
○

KITO EQ series Specifications

General

Brand	KITO
Model	EQ series
Category	Chain Hoists
Language	English