KITO ER2 - Deformation and Damage of each Part; Indication of Nameplates and Labels; Operational Check

155
• When any abnormality is observed during inspection, stop the use of
electric chain hoist, indicate “FAILURE”, and contact the maintenance
engineer or KITO for repair.
Use of the product with abnormality may result in death or serious injury.
Mandatory
Decide the check items
appropriate to the
environment and operating
conditions of the customer.
NOTE
A
Check Sheet for ER2 Series Electric Chain Hoist Daily inspection
■
Motorized Trolley MR2 Daily Inspection
■
Check result :
○
Good,
△
To be replaced (adjusted) next inspection,
×
Bad, Needs replacement (adjustment)
Category Check item Check method Criteria
Inspection date/result
/ / / / / /
Appearance
Indication of nameplates
and labels
Visual inspection To have no peeled off. To be legible clearly.
Deformation and
damage of each part
Visual inspection
To have no apparent deformation and corrosion
Frame to have no apparent deformation
Bolts, nut, split pins
Visual inspection
or inspection with
tools
To have no loosened bolts, nuts, and split pins that
can be seen from exterior. To have no come-off.
Function/performance
Operational check
Traveling
operation with no
load
• To travel smoothly. To have no serpentine motion
and vibration.
• Electric Chain Hoist operates in the same direction
as that of the push button operation
• Motor to stop immediately when stopping the
operation
• All operations to stop when Emergency Stop is
pressed
• Electric Chain Hoist not to operate when pressing
the push button while Emergency Stop is pressed
• Electric Chain Hoist to operate normally when
canceling Emergency Stop
Brake
Traveling
operation with no
load
When stopping the operation, brake to operate
securely and motor to stop immediately.
Executed by Inspector
Checked by Maintenance Engineer
■
Manual Trolley TS2 (TSG/TSP) Daily Inspection
■
Check result :
○
Good,
△
To be replaced (adjusted) next inspection,
×
Bad, Needs replacement (adjustment)
Category Check item Check method Criteria
Inspection date/result
/ / / / / /
Appearance
Indication of nameplates
and labels
Visual inspection To have no peeled off. To be legible clearly.
Deformation and
damage of each part
Visual inspection
• To have no apparent deformation and corrosion
• Frame to have no apparent deformation
Bolts, nut, split pins Visual inspection
To have no loosened bolts, nuts, and split pins that
can be seen from exterior. To have no come-off.
Function/
performance
Operational check
Traveling
operation with no
load
• To travel smoothly. To have no serpentine motion
and vibration.
Executed by Inspector
Checked by Maintenance Engineer
DANGER