Kiturami TURBO CONDENSING - 13 - Bath Operation; Run Bath Operation; Setting up Hot Bath Water Temperature

OIL CONDENSING BOILER
INSTALLATION AND USER MANUAL
INSTALLATION & USER MANUAL www.krb.co.kr 39
4.5 Bathing function
4.5.1 Execute bathing function
1
To use a large volume of hot water, select the Bath
mode.
2
After 2 hours and 30 minutes after Bath setting,
the setting will be reset and the system will return
to the previous function.
4.5.2 Setting up bath water temperature
1
Press Bath button to enter Bath mode.
2
In this mode, press the Bath button for 5 sec. The
display will flash as shown in the figure.
3
Bath water temperature can be set up between 41
℃~85 ℃, at 1 ℃ unit
4
The setting will be entered and effective after
about 10 seconds, if without any button input.
5
After setting, press the Function or Bath button to
complete the setting and enter the respective
function or Bath function.
• Take care of burn injury when using hot water.
• When using hot water, very hot water may come out of the hot water faucet.
Take special care for children and senior people.
• The water from the boiler system is not potable.
• After a long time of using hot water in heating mode, the water temperature
may be reduced.
• If the power turns Off and On in bath mode, the system will return to the mode
prior to bath.