9
RETAIL CUSTOMERS RESPONSIBILITY UNDER THE KMC WARRANTY:
The retail customer’s responsibilities are:
1. To read the Operator’s Manual and operate the KMC Rip Strip in accordance
with the instructions given in this manual.
2. To inspect the KMC Rip Strip daily, lubricate as specified and repair or replace
parts as needed, especially when continued use would cause damage or exces-
sive wear to other parts.
3. To maintain and keep in place all safety shields, decals and devices.
4. When warranty service is necessary, it is the customer’s responsibility to deliver
the machine to the KMC dealer from which it was purchased. Warranty repairs
should be submitted to the dealer within thirty (30) days of failure.
5. Dealer travel to the machine or hauling the machine to his shop for the purpose
of performing warranty service is not allowed under KMC warranty. It is a cost
to be paid for by the retail customer. Any arrangement whereby the dealer
agrees to absorb all or part of this cost is strictly between the dealer and the
retail customer.
2. Do not permit anyone to ride on the
machine at any time.
3. Before starting or operating the machine,
make a walk-around inspection and check
for obvious defects such as loose mounting
bolts and damaged components. Correct
any deficiencies before starting. (The
equipment must be properly maintained
and guarded and must be suitable to per-
forming its task.)
1. All persons operating this piece of equipment should READ the Owner’s
Manual.
4. Keep all persons a safe distance away from all sides of the machine while it is
in operation.
SAFETY PROCEDURES:
Safety and performance are the primary
objectives of the designers of KMC
equipment. Safety features have been
incorporated into this machine where possible
and warnings given in other areas. For your
safety, PLEASE read and observe the
following safety procedures.
To Next Page
Loading...
Need help?
General
