TP-6694 7/18 Appendix 121
Appendix E Controller Displays from the Engine ECM
The controller display showing engine information is
dependent upon the engine manufacturer and the
corresponding Engine Control Module (ECM). The
following list indicates which engine displays are
available by the engine manufacturer. This information
is subject to change by the engine manufacturer.
Note: See the generator set specification sheet for
engine model identification.
Some engines do not have an ECM and in some cases
the ECM information is not available as a controller
display. In these situations, critical information like oil
pressure and coolant temperature are displayed by the
controller using independent engine sensors not used
by the ECM.
Controller Displays
as Provided by the
Engine ECM
Engine Manufacturer (and model)
Kohler
Diesel
(KDI M, TM*)
Kohler
Diesel
(KDI TCR)
Kohler Gas
(KG2204,
KG2204T)
GM/ PSI and
Kohler Gas
(KG6208,
KG6208T)
DD/MTU Doosan
John
Deere
Volvo
Intake air pressure S/D D
Intake air Temperature D D S/D D D D
Coolant level D D D D D D
Coolant temperature D C/S/D C/S/D C/S/D C/S/D C/S/D C/S/D
Crankcase pressure D
ECM battery voltage S S/D S S S
Engine model number S S S S S S S
Engine serial number S S S S S S S
Engine speed C/S/D C/S/D C/S/D C/S/D C/S/D C/S/D C/S/D C/S/D
Fuel pressure D C/S/D C/S C/S/D
C/S[
C/S/D
Fuel rate S S S S S
Fuel temperature D S S/D S
Oil level
S[ S/D[ S[ S[ S[
Oil pressure C/S/D D C/S/D C/S/D C/S/D C/S/D C/S/D
Oil temperature S D SD
C = Value displayed on controller, S = Value displayed in Site Tech, D = ECU diagnostic is supported
* Electronic governor and ECM are optional on KDI M and TM engines.
[ Controller uses local analog input to obtain this information
NOTE: REOZMD/ROZMC (Mitsubishi engines) have an ECM but do not send signals to the generator set controller.
To Next Page
Loading...
