TP-6694 7/1850 Section 2 Operation
2.7 Reviewing Menu Displays
Use this section to review a summary of the generator
set controller data. See Figure 2-17 or Figure 2-18 for
which menus provide data monitoring, data
adjustments, or require SiteTecht software to make
data adjustments.
Use the pushbutton/rotary selector dial to navigate to
the respective menus.
Menu Name
Controller
Viewable
Controller
Adjustable
SiteTech
Adjustable
Overview X
Engine Metering X
Generator Metering X
GenSet Information X X
GenSet Run Time X
GenSet System X X X
GenSet Calibration X X
Voltage Regulation X X X
Digital Inputs X X
Digital Outputs X X
Analog Inputs X X
Event Log X
Figure 2-17 Menu Displays for Viewing and Adjusting
(DEC3000 Before Firmware
Version 3.0.25)
Menu Name
Controller
Viewable
Controller
Adjustable
SiteTech
Adjustable
Overview X
Engine Metering X
Generator Metering X X
GenSet Information X X
GenSet Run Time X
GenSet System X X X
Voltage Regulation X X X
Digital Inputs X X
Digital Outputs X X
Analog Inputs X X
Event Log X
Volt Select X X X*
* Requires initial activation using SiteTecht
Figure 2-18 Menu Displays for Viewing and Adjusting
(DEC3000 Firmware Version 3.0.25 to
4.8.4)
Menu Name
Controller
Viewable
Controller
Adjustable
SiteTech
Adjustable
Overview X
Engine Metering X
Generator Metering X X
GenSet Information X X
GenSet Run Time X
GenSet System X X X
Voltage Regulation X X X
Digital Inputs X X
Digital Outputs X X
Analog Inputs X X
Battery Charger 1 X X
Battery Charger 2 X X
Event Log X
Volt Select X X X*
* Requires initial activation using SiteTecht
Figure 2-19 Menu Displays for Viewing and Adjusting
(DEC3000 firmware version 4.8.4 and
higher, and APM402)
See Section 1, Specifications and Features, to review
set point ranges and default settings for comparison to
the actual setup.
Menus displaying the # symbol represent one of the
following data types:
D System-calculated data
D System-measured data
D User-entered data
Note: The examples given on the following pages
represent digital displays with the Measurement
System set to English.
Some displays are engine-dependent. Refer to the
Appendix, Controller Displays from the Engine ECM.
To Next Page
Loading...
