TP-6694 7/1846 Section 2 Operation
Procedure for Powering Up the Engine ECM
This procedure applies to Decision-Makerr 3000
controllers with firmware version 3.10 and higher and to
APM402 controllers with firmware versions 1.0 and
higher.
1. Navigate to the SW Version menu (Figure 2-10) as
described in the previous procedure. Press and
hold the selector dial until the display screen
confirms that the ECM is powered as shown in
Figure 2-11.
SW Version:
3.10
Figure 2-10 SW Version Display
ECM
Powered
Figure 2-11 ECM Powered Display
2. After several seconds, the display will change to
provide the option to power down the controller.
See Figure 2-12.
ECM powered
Push to Stop
Figure 2-12 ECM Power Down Display
3. If desired, press the selector dial to power down the
engine ECM.
OR
Rotate the selector dial to navigate to any of the
available menus.
Procedure for Powering Up the Engine ECM using
SiteTecht (for Decision-Makerr 3000 controllers
with Firmware Versions Before 3.10)
Connect a PC with SiteTecht software to the generator
set controller. Refer to the SiteTecht Software
Operation Manual TP-6701 as needed.
Follow the instructions shown in Figure 2-13.
1. Locate Genset System Configuration--ECM Power in
SiteTecht
2. Click drop down arrow and select True to power up the
engine ECM
SB-724
1
2
Figure 2-13 SiteTecht Software Display Screen
2.5 Menu Displays
Use the Menu Summary List section after reading and
understanding the features of the pushbutton/rotary
selector dial. See Section 1.2.3, Digital Display.
The Menu Summary List provides a quick reference to
the digital display data. Some digital display data may
not be identical to your display due to generator set
application differences. The closed bullet items
represent main level data and the open bullet items are
sub-level data. The Menu Summary List indicates items
that are user selectable. Use SiteTecht software for
changing all other programmable information.
Some displays are engine dependent; refer to the
Appendix, Controller Displays from the Engine ECM.
Section 2.7, Reviewing the Menu Displays, provides a
digital display menu overview and explains the
navigation using the pushbutton/rotary selector dial.
To Next Page
Loading...
