TP-6461 1/08 Appendix 117
Set Source
D Phase Rotation ABC/BAC/Disabled
D In-Phase Monitor Enable/Disable
D In-Phase Monitor Angle
D Set Preferred Source Normal/Emergency
D Set Normal (Emergency) Source:
d Number of Phases
d Voltage
d Frequency
d Under Voltage Pickup
d Under Voltage Dropout
d Over Voltage Pickup
d Over Voltage dropout
d Voltage Debounce Time
d Voltage Unbalance Enable/Disable
d Voltage Unbalance Pickup
d Voltage Unbalance Dropout
d Under Frequency Pickup
d Under Frequency Dropout
d Over Frequency Pickup
d Over Frequency Dropout
d Frequency Debounce time
Set Input/Output
D Set Main Board I/O
d Set Input Functions *
d Set Output Functions *
D Set Auxiliary I/O (Modules)
d Set Input Functions *
d Set Output Functions *
* See the ATS Operation and Installation Manual for more
information about programmable inputs and outputs.
Set Common Alarms
D Alarm Group 1 or 2
D Modify Alarm
d Alarm Description
d Common (Yes/No)
d Audible (Yes/No)
D Remove All Alarms Yes/No
Set System
D Source Type: Utility/Generator, Generator/Generator,
Utility/Utility, Utility/Generator/Generator (3--source system)
D Transition Type: Standard/Programmed
D Rated Current, Amps
D 3 Source Engine Start Mode
d Mode1/Mode2
d Preferred Source Toggle Enable/Disable
D Transfer Commit Commit/No Commit
D Remote Test Loading Loaded/Unloaded
D Peak Shave TD Bypass Enable/Disable
Set Communications
D Modbus Server TCP Enable/Disable
D Modbus Server Port 1 or 2
Enable/Disable
D Modbus Address Port 1 or 2
D Baud Rate Port 1 or 2
9600/19200/57600
D Modbus TCP Unit ID
D IP Address
D Subnet Mask
Set Passwords
D Setup Password
D Test Password
Calibration
D Line-Neutral Voltages, Source N and E
D Line-Line Voltages, Source N and E
D Load Current, LA, LB, and LC
Reset Data
D Reset Maintenance Records, Yes or No
D Reset Event History, Yes or No
D Reset Default Parameters, Yes or No
D Reset Exercise Setup, Yes or No
D Reset Test Password, Yes or No
D Disable Test Password, Yes or No
D File Maintenance
d Delete Files
d Force History Save
USB Access Screen (appears only when a device is
connected to the USB port)
D Download to Controller
D Upload to USB
To Next Page
Loading...
