TP-5660 11/98IV Safety Precautions and Instructions
Moving Parts
Hazardous voltage.
Movingrotor.
Can cause severe injury or death.
Operate generator set only with all
guards and electrical enclosures in
place.
WARNING
Notice
NOTICE
Hardware damage! Transfer switch
may use both American Standard and
metric hardware. Use the correct size
tools to prevent rounding of bolt heads
and nuts.
NOTICE
When replacing hardware, do not
substitute with inferior grade
hardware. Screws and nuts are
available in different hardness ratings.
American Standard hardware uses a
seriesofmarkingsandmetrichardware
uses a numeric system to indicate
hardness. Check markings on bolt
head and nuts for identification.
NOTICE
Improper operator handle usage!
Use the manual operator handle
provided on the transfer switch for
maintenance purposes only. Return
the transfer switch to the normal
position. Remove manual operator
handle, if used, and store it on the
transfer switch in the place provided
when service is completed.
NOTICE
Foreign material contamination!
Cover transfer switch during
installation to keep dirt, grit, metal drill
chips, etc., out of components. Cover
solenoid mechanism during
installation. After installation, use
manual operating handle to position
contactor to ensure that it operates
freely. Do not use a screwdriver to
force contactor mechanism.
NOTICE
Electrostatic discharge damage!
Electrostatic discharge (ESD)
damages electronic circuit boards.
Prevent electrostatic discharge
damage by wearing an approved
grounding wrist strap when handling
electronic circuit boards or integrated
circuits. An approved grounding wrist
strap provides a high resistance(about
1 megohm), not a direct short, to
ground.
To Next Page
Loading...
Need help?
General
