TP-5660 11/98 Introduction i
Introduction
This manual provides operation and installation
instructions for Kohler Model ZCS automatic transfer
switchesthatusea40-to3000-amperecontactorasthe
power switching device.
All information in this publication represents data
availableattimeofprint. KohlerCo.reservestherightto
change this literature and the products represented
without incurring obligation.
Read through this manual and carefully follow all
procedures and safety precautions to ensure proper
equipment operation and to avoid bodily injury. Read
and follow the Safety Precautions and Instructions
section at the beginning of this manual. Keep this
manual with equipment for future reference.
Equipment service requirements are minimal but are
veryimportanttosafeandefficient operation;therefore,
inspect parts often and perform required service at the
prescribed intervals. An authorized service distributor
or dealer (authorized service center) should perform
required service to keep equipment in top condition.
List of Related Materials
This manual covers operation and installation
information for the transfer switch’s power switching
device. Decode the transfer switch part number model
codefrom the transferswitch nameplateand verify that
the transfer switch’s power switching device matches
that what is shown on the front cover of this manual
before proceeding with operation or installation.
A separate operation and installation manual that
covers information specific to the transfer switch’s
electricalcontrols(logiccontroller)completesoperation
and installation instructions for the transfer switch.
Three types of electrical controls are available on the
ModelZCS transferswitch, andeach typeis coveredin
a separate manual. The following table lists the
available electrical controls and the related operation
and installation manual part numbers.
Electrical Controls
Operation/
Installation
Manual
E33+ (Solid State) TP-5662
S340+ (Solid State) TP-5663
M340+ (Microprocessor) TP-5664
Separate manuals cover service and parts information
for transfer switch power switching devices and
electricalcontrols. Thefollowingtableliststheavailable
manuals and the related manual part numbers.
Power Switching Device
Service/Parts
Manual
ZCS/ZCB (Contactor) TP-5668
Electrical Controls
Service/Parts
Manual
E33+ (Solid State) TP-5670
S340+ (Solid State) TP-5671
M340+ (Microprocessor) TP-5672
Transfer switches with microprocessor electrical
controls and communication accessories can be
monitored and controlledwith apersonal computerand
software. Thefollowingtableliststheavailablemanuals
and part numbers.
Communications Item
Operation/
Installation
Manual
Remote Monitoring and Control
Communications (Monitor) Software
TP-5823
Communications Kits TT-847
To Next Page
Loading...
Need help?
General
