Warning:
• Do not operate equipment that has been damaged.
• Refer all maintenance to qualified personnel.
• Instruct all personnel in the proper use of the equipment.
• Clean up any liquid spills immediately.
• Always install equipment on a stable and level surface.
• All models are intended for indoor use only. Do not install the equipment in unprotected
outdoor areas.
• Always securely attach individual component sections together. (Bins, Bagging Machines,
Dispensers, Crushers, Ice Machines etc.
• Do not install the equipment in wet areas.
• Do not locate the equipment near any heat source, in direct sunlight, in high ambient areas, or
without proper clearance for ventilation. Placing equipment in these locations will result in
reduced capacities, high system pressures and may cause equipment failure.
Note: Each Kold-Draft ice machine has successfully completed a quality assurance test and has
been factory inspected before shipping. When receiving the unit please inspect it for physical
damage. If damage is found:
1. Have carrier note the damage on the bill of lading.
2. File a damage claim report with the carrier immediately.
3. Call Kold-Draft with your claim number to arrange replacement or repair.
What’s in the Box
• Kold-Draft Ice Machine
• Warranty card attached to the front of the machine
• Two ice deflectors (four ice deflectors with a GB106x machine)
• Drain Pan hose with clamp (Two hoses and two clamps with a GB106x machine)
• Adhesive-backed foam weather-strip tape
• Information packet
o Installation And Operation Manual
o 4x 1/4-20 stainless steel bolts
o 4x 1/4” stainless steel washers
o 2x 8-32 pan head stainless steel Philips head screws
Required Tools
• #2 Philips Head Screwdriver
• 7/16” Socket and Wrench
• Channel Lock Pliers
To Next Page
Loading...