Figure 3-10
Note:”Read from module” is a function used to read the stored message in the
system which is set by the receiver via GPRS link. Click “Read from module”, the
previous message will be filled in the “Access” field：
3) Input the network configuration information in turn, select "Eagle" for the
Base station, in “Access” please input machine number or customize.
After setting, click "OK." and enter parameter configuration phase. And then
click "OK" to return to the network configuration interface. Then click on
“Connect” button to enter the EGStar initial interface, after connecting to
network, click on “OK” and return to EGStar main interface.
To Next Page
Loading...