OM7007 Radio / CD Player - Section 70
Page 70-5
USING THE RADIO
Finding a Station
BAND/AUTO: Press this button to switch between
FM1, FM2, AM and WX.
TUNE: To tune the radio manually, press the up/
down button once to tune to the next higher or lower
station, one frequency at a time.
SEEK: Press the or button once to tune to
the next available station. The SEEK mode ends
once it reaches a tunable station.
If either the or button is pushed while the
radio is finding a station, the tuner will stop at the fre-
quency tuned at the time the button was pressed.
If SEEK does not find a tunable station, it displays
NO STATION FOUND. The radio remembers the sta-
tion that was tuned when SEEK was initiated and
goes back to that frequency if SEEK is cancelled.
The audio mutes during the SEEK UP/DOWN pro-
cess.
To cancel SEEK:
• Switch modes including: power off, ignition off,
switch to CD, Radio, MP3, WMA, USB, AUX or
iPod
• Change bands
• Press SCAN/PSCAN button
• Press any preset button
• Disconnect battery
• Press and hold SCAN/PSCAN button
• Press and hold BAND/AUTO button
AUTO STORE: AUTO STORE temporarily stores the
6 strongest stations onto pushbuttons 1-6. Press and
hold the BAND/AUTO button for more than 2 sec-
onds. A beep will sound and AUTO STORE will
appear on the display until all of the presets have
been saved in the band. AS will be displayed while
AUTO STORE is active. Pressing BAND/AUTO will
not affect the other bands. For example: if BAND/
AUTO is pressed while listening to FM1, the presets
on AM, FM2, and WX will not change. Pressing and
holding BAND/AUTO again will cancel AUTO
STORE, and the original presets will be restored.
SCAN: Press SCAN/PSCAN and release to scan all
stations on the band that are being used. When a
strong enough frequency is found, the radio will play
for 8 seconds before continuing to scan. To end the
scan, press SCAN/PSCAN again. The radio will beep
and display SCAN plus the frequency.
PSCAN: Press and hold SCAN/PSCAN for more
than 2 seconds to scan the presets on the band
being used. When a strong enough frequency is
found, the radio will play that station for 8 seconds
and then continue scanning. The display will show
PSCN, the frequency, preset number and the current
band. Preset scan will continue until the SCAN/
PSCAN button is pressed again.
Setting the Presets
The six numbered buttons allows six favorite presets
to be stored per band and easily return to them with
the touch of a button. To set the presets:
1. Turn the receiver on.
2. Select the band.
3. Tune to the desired station.
4. Press and hold one of the 6 numbered buttons
for more than 2 seconds to store the selected
station. During the 2-second set time, the radio
will be muted and the preset number will be dis-
played. When the preset station has been set, a
beep will sound, then the audio and selected
preset number will return.
5. Repeat steps 1-4 for each button.
Pressing a preset button in the future will tune the
radio to the station previously set on the band cur-
rently in use.
To Next Page
Loading...
