Kongsberg SIMRAD CP40 - Default Chapter; Table of Contents

CP40/50 DGPS Chartplotter Table of contents
1. Introduction and system
familiarization
1.1 Introduction and system
familiarization, 5
1.2 Safety summary, 6
2. Fundamentals & initial start-up
2.1 Fundamentals of the PAGE and
WINdow system, 7
2.2 Key functions, 10
2.3 Menu bar, 12
2.4 Menu layout, 13
2.5 Choice of symbols, 14
2.6 Naming of routes, points, etc., 14
2.7 Initial start-up, 15
2.8 Turn power off, 16
3. Chart menus and
INFO windows
3.1 Chart menu, 17
3.1.1 Charts, 17
3.2 C-MAP cartridges, 20
3.3 INFO windows, 22
3.3.1 Cursor inactive, 22
3.3.2 Cursor not placed on object
or user data, 23
3.3.3 Cursor placed on waypoint, 24
3.3.4 Cursor placed on route leg
or line leg, 25
3.3.5 Cursor placed on routepoint
or linepoint, 26
3.3.6 Cursor placed on trackpoint, 27
3.3.7 Cursor placed on target, 28
3.3.8 GOTO function, 29
3.3.9 PLOT function, 30
3.4 Chart setup, 32
4. Position menus
4.1 Position display, 35
4.2 Set & drift, 39
4.3 Speed diagram, 40
4.4 Dual speed display, 41
4.5 Wind display, 42
4.6 MOB position, 44
4.7 Satellite status, 45
4.8 DGPS setup, 47
4.9 DSC alarm, 49
5. Waypoint / route menus
5.1 WP list, 51
5.2 Routes stored in the memory, 52
5.3 Route calculation, 54
5.4 Lines stored in the memory, 55
5.5 Start / stop track, 56
5.6 Tracks stored in the memory, 58
5.7 Targets stored in the memory, 59
5.8 Data transfer via DataCard, 60
6. Navigation menus
6.1 NAV menu (NAV inactive), 63
6.1.1 - Navigation display, 63
6.2 NAV menu – (NAV active), 65
6.2.1 - Navigation display, 66
6.2.2 - Navigation setup, 67
6.2.3 – Turn NAV off, 67
6.2.4 – ETA & AVN, 67
6.2.5 – Set & drift trim display, 69
6.2.6 – Waypoint advance, 69
6.3 Anchor guard, 70
6.4 MOB navigation, 71
6.5 Navigation examples, 71
6.5.1 Chart/cursor navigation, 72
6.5.2 Waypoint navigation, 73
6.5.3 Route navigation, 74
6.5.4 Track navigation, 77