3-8
HINTS
See the table on the following
page for the relation of origi-
nal size, magnification ratio
and copy paper size.
1
2
3
4
HINTS
The initial settings may have
been altered by Key operator.
See p. 12-6 to p. 12-12.
HINTS
HINTS
See p. 3-7 for details on set-
ting print quantity.
• See p. 9-5 to p. 9-6 for pa-
per sizes detectable from the
RADF or on the platen glass.
• See p. 3-2 to p. 3-6 for de-
tails on positioning originals.
• Key operator can deactivate
APS when original is set in
the RADF or on the platen
glass. See p. 12-35 to p. 12-
39.
Selecting Paper Size
To select an appropriate paper size for getting your desired copy result, use APS
(Automatic Paper Selection), or select paper size manually on the touch screen, as
required.
â– To Select Paper Size Automatically (APS)
APS detects the size of originals placed on the RADF
or platen glass and automatically selects and feeds copy
paper of the same size, or selects an appropriate size
according to the magnification ratio selected.
Touch to highlight
APS
at lower
right corner of the Basic Screen.
APS
is already highlighted when the initial set-
tings are restored.
Select additional copy conditions, as
desired.
Enter the desired print quantity from the
control panel keypad.
Position original(s).
To Next Page
Loading...
Need help?
General
