5-2
1
A “Call for Service” message indicates a machine condition that requires the attention
of your Konica service centre.
The Call for Service Screen usually displays the telephone and facsimile numbers of
your service centre.
Make note of the Report code No.
indicated in the second line of the
message area.
2
Please Be Reminded!Please Be Reminded!
CAUTION
When the Call for Service Screen is displayed,
be sure to contact your Konica service centre
immediately by following the procedure below.
Turn OFF the power switch and main
power switch.
In the event the machine with
the Remote Diagnostics op-
tion is automatically monitored
by a Konica service centre, the
key operator can call for ser-
vice using the key operator
setting. See p. 12-43.
After calling for service using
the key operator setting, be
sure to turn OFF the power
switch and main power switch
immediately, then unplug the
machine as described here.
When “Call for Service” Message Is Displayed
Report code No.
Telephone number
of your service
Fax. number of your
service
To Next Page
Loading...
Need help?
General
