Konica Minolta DiMAGE A2 - Changing the Memory Card (Data-Transfer Mode)

156
D
ATA-TRANSFER MODE
CHANGING THE MEMORY CARD (DATA-TRANSFER MODE)
Care should be taken when changing memory cards while the
camera is attached to the computer. Data could be lost or
damaged if the camera is not properly disconnected. Always
confirm the access lamp is out before removing the memory card.
WINDOWS 98 / 98 SECOND EDITION
1. Turn off the camera.
2. Change the memory card.
3. Turn on the camera to remake the USB connection.
WINDOWS ME, 2000 PROFESSIONAL, AND XP
MACINTOSH
1. Stop the USB connection using the unplug-or-eject-hardware routine (p. 154).
2. Turn off the camera.
3. Change the memory card.
4. Turn on the camera to remake the USB connection.
1. Stop the USB connection by dragging the drive icon into the trash (p. 155).
2. Turn off the camera.
3. Change the memory card.
4. Turn on the camera to remake the USB connection.