89
Press and hold the mounting-foot-release button (1)
to disengage the safety catch to remove the flash
unit from the camera.
Position the camera and flash around the subject.
See the following page for the camera-to-subject
and flash-to-subject ranges. Make sure no objects
come between the camera and flash unit.
Raise the built-in flash on the camera. The wireless flash indicator
(WL) will be displayed in the top left corner of the live image. The
number next to it indicates the channel in use. The flash signal will turn
white when the flash is charged.
2
1
When the 5600HS(D) and 3600HS(D) flash is charged, the AF
illuminator on the front of the unit will blink (2). Take a picture as
described in the basic recording section on page 33.
The flash units can be test fired by pressing the AEL button on the
camera. If the flash does not fire, change the camera, flash, or subject
position. The slow-shutter-sync function will be active in P and A
exposure modes (p. 87).
To Next Page
Loading...
