Replacing Consumables148
Replacing the Transfer Belt Unit
When the time to replace the transfer belt unit is reached, the message
TRANS. BELT/END OF LIFE appears. Printing can continue even after
this message appears; however, since the print quality is reduced, the trans-
fer belt unit should be replaced immediately.
1 Turn off the printer and discon-
nect the power cord and inter-
face cover.
2 Open the printer’s front cover.
3 Remove the all imaging units
and waste toner bottle.
" For details on removing
the imaging unit or waste
toner bottle, refer to
“Replacing a Imaging
Unit” on page 135 or
“Replacing the Waste
Toner Bottle” on page
141.
" Cover the removed imag-
ing unit to protect it from
direct sunlight.-
To Next Page
Loading...
