Korg drumlogue - Master Effect Parameters and Types

41
PARAMETERS
TIME [0.0%...100.0%]
Adjusts the reverb time.
INPUT [0.0%...100.0%]
Adjusts the signal level of the reverb input.
BRIGHT [0.0%...100.0%]
Adjusts the tone (brightness) of the reverb.
RISE (Riser only) [0.0%...100.0%]
Adjusts the pitch-shifted reverb sound signal on the octave.
DIVE (Submarine only) [0.0%...100.0%]
Adjusts the pitch-shifted reverb sound signal below the octave.
MIX/ROUTE
LEVEL [0.0%...100.0%]
Adjusts the amount of the reverb eect.
RETURN [PRE, POST]
Select whether to put the reverb eect before or after the master eect.
MASTER (Master Eect)
SOUND SELECT
SELECT [---, Compressor, Filter, Boost, EQ Three, ...*]
Select the type of master eect.
Compressor: A basic compressor that raises the sound pressure.
Filter: A multi-mode lter with cuto resonance.
Boost: A booster with adjustable center frequency and saturation.
EQ Three: A 3-band equalizer with adjustable crossover frequency.
* You can also add master eects created with the logue SDK (→ p.52 "Loading
user synth and effects").
PARAMETERS - For Compressor
THRESH (THRESHOLD) [-64.0dB...0.0dB]
Adjusts the threshold at which the compressor begins to apply.
ATTACK [0.5ms...100ms]
Adjusts the aack time that the compressor responds to.