Korg drumlogue - Page 42

42
RELEASE [50ms...1s]
Adjusts the release time of the compressor.
RATIO [1...10]
Adjusts the compression ratio of the compressor.
MAKEUP [0.00dB...8.00dB]
You can increase the overall gain of the signal to compensate for compression.
KNEE [0.00dB...8.00dB]
Adjusts the smoothness at the beginning of the compressor eect.
SIDECH (SIDECHAIN) [OFF, ON]
If you want to enable the input signal from SIDECHAIN, set this parameter to ON.
WET [0.0%...100.0%]
Adjusts the ratio of eect sounds. The greater the value, the more the signal is compressed.
PARAMETERS - For Filter
MODE [THRU, LPF 2, LPF 4, BPF 2, BPF 4, HPF 2, HPF 4]
Select Filter mode.
There are six types in total, two types each for low pass, band pass, and high pass.
SATURATE [0.0%...100.0%]
Adjusts the saturation amount of the lter.
RESON (RESONANCE) [0.0%...100.0%]
Adjusts the resonance of the lter.
CUTOFF [0.0%...100.0%]
Adjusts the cuto frequency of the lter.
PARAMETERS - For Boost
CENTER [0.0%...100.0%]
Adjusts the center frequency you want to boost.
WIDTH [0.0%...100.0%]
Adjusts the frequency bandwidth from the center frequency you want to boost.
SATURATE [0.0%...100.0%]
Adjusts the saturation amount of the booster.