133
Card Edit environment
File and folder size display
FILE AND FOLDER SIZE DISPLAY
The size of any file and folder in the card can be seen in
the display.
The single file size is always shown on the right of the
file:
To see a folder size, first move it to the first line of the
display, then keep the SHIFT button pressed, and press
the F-3 (OPEN) function button under the display. A
dialog box will appear, showing the size of the folder:
Press EXIT to exit this dialog.
PAGE STRUCTURE
Here is the typical structure of a Card page.
Operating mode icon
When in the Card Edit environment, one of the operat-
ing modes is still active in the background. The operat-
ing mode icon shows which mode is currently active.
Press EXIT to go back to the current operating mode
from any of the Card pages.
Page header
This line shows the Card page you are in.
Card content
These lines show the content of the current folder.
Move the item to select to the first line, using the E–F
(Scroll Up) and G–H (Scroll Down) VOLUME/VALUE
buttons, or the TEMPO/VALUE controls.
Use the Page commands (F-1–F-4) on the last line to
execute an operation on the selected file or folder.
The “ ” symbol before a name identifies a folder (i.e.,
a “folder” containing other files).
Page commands
You can use these commands to browse through files
and folders, and to execute data transfer commands
(load, save…). Commands may be different in any
Card page. Use the F-1–F-4 buttons to select the corre-
sponding command.
NAVIGATION TOOLS
When in a Card page, you can use any of the following
commands to browse through the files and folders, or
through the list of commands.
E–F (Scroll Up)
Scroll the list up. Keep SHIFT pressed and press one of
these buttons to jump to the previous alphabetical sec-
tion.
G–H (Scroll Down)
Scroll the list down. Keep SHIFT pressed and press one
of these buttons to jump to the next alphabetical sec-
tion.
TEMPO/VALUE section
These controls scroll the list up or down.
F-1 (SD)
Press this button after replacing a card in the card slot.
After pressing this button, the new card will be
scanned, and the file list shown on the display will be
updated.
F-2 (Data transfer command)
Executes the shown operation.
F-3 (OPEN)
Opens the selected folder or bank (files whose name
begins with the “ ” icon.
F-4 (CLOSE)
Closes the current folder, returning to the parent
(“upper”) folder.
Operating mode icon
Page header
Page commands
Card content
To Next Page
Loading...
