64
Style Record mode
Page 5 - Event Filter
Length
Length of the selected Note event. The value format is
the same as the Position value.
Note: If you change a length of “000.00.000” to a different
value, you can’t go back to the original value. This rather
uncommon zero-length value may be found in some drum or
percussion tracks.
Transport, navigation and editing controls
E/F and H VOLUME/VALUE buttons
These buttons are the “Scroll to previous event” (E/F)
and “Scroll to next event” (H) controls. They corre-
sponds to the scrolling arrows shown on the screen.
G VOLUME/VALUE buttons
Use these buttons to select the corresponding parame-
ter value area.
F-3 and F-4 buttons
After selecting the parameter value area with the G
VOLUME/VALUE buttons, use these buttons to select,
respectively, the first and second value of the event in
edit.
START/STOP button
Press START/STOP and play some chords on the key-
board to test the pattern in edit. Press START/STOP
again to stop the pattern running.
SHIFT + << or >>
Keep the SHIFT button pressed and press the << or >>
button to open the Go to Measure window.
Use the TEMPO/VALUE controls to select a measure,
then press ENTER to confirm, or EXIT to abort.
INSERT
Press the INSERT button to insert a new event at the
current shown Position. The default values are Type =
Note, Pitch = C4, Velocity = 100, Length = 192.
After inserting an event, use the C VOLUME/VALUE
buttons to select the Event line, and the same buttons
or the TEMPO/VALUE controls to select a different
event type.
DELETE
Press the DELETE button to delete the event shown in
the display.
PAGE 5 - EVENT FILTER
This page is where you can select the event types to be
shown in the Event Edit page. You can access this page
by pressing the PAGE+ button, while you are in the
Event Edit page.
Turn Off the filter for all event types you wish to see in
the Event Edit page.
Note: Some of the events are “ghosted”, and non editable,
since the corresponding events are not editable in a Style.
Note Notes.
Ctrl Control Change events. Only the follow-
ing Control Change numbers are allowed.
Bend Pitch Bend events.
Control function CC# (Control Change Number)
Modulation 1 1
Modulation 2 2
Pan 10
Expression
(a)
(a) Expression events cannot be inserted at the starting Position
(001.01.000). An Expression value is already among the default “header”
parameters of the Style Element.
11
CC#12 12
CC#13 13
Damper 64
Filter Resonance 71
Low Pass Filter Cutoff 74
CC#80 80
CC#81 81
CC#82 82
To Next Page
Loading...
