EasyManua.ls Logo

Korg Liverpool - Troubleshooting

Korg Liverpool
246 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
240
Error messages & Troubleshooting
Troubleshooting
TROUBLESHOOTING
Problem Solution Page
General problems
Power does not turn on Make sure that (1) the power cable is plugged into the outlet, (2) the cable is plugged into the connector on
the back of the instrument, (3) and is not damaged, (4) there are no problems with the mains.
Is the power switch turned ON?
If the power still does not turn on, contact your dealer or the nearest KORG Service Center.
No sound Is a jack connected to the HEADPHONES connector? This would disable the internal speakers. 22
Check the connections of your amp or mixer. 22
Make sure that all the components of the amplifying system are turned on.
Are the MASTER VOLUME or ASSIGN.SLIDER sliders of the Liverpool set to a position other than “0”? 12
Is the Local parameter set to Off? Turn it On. 128
Is the Speaker parameter set to Off? Turn it On. 126
Is the Attack parameter value too high? Set it to a lower value, to let the sound start faster. Is the Volume
parameter too low? Set it to a higher value.
43
45
Lowest note are not played When the SPLIT button is lit up, the keyboard will be divided into the Lower part (low notes, below the split
point) and the Upper part (high notes, above the split point). Is the Lower track muted? Unmute it.
24
Wrong sounds Do the USER banks contain modified data? Load the appropriate data for the Song or the Style you wish to
playback.
134
Has one of the USER Drum Kits been modified? Load the appropriate Drum Kits. 134
Have the Styles or Performances been modified? Load the appropriate data (Styles or Performances). 134
Sound does not stop Make sure that the damper switch polarity parameter is set correctly. 127
The selected Style or Song cannot
start
Make sure that the Clock parameter is set to Int. If you are using the MIDI Clock of another device, you must
set the MIDI Clock parameter to MIDI, and make sure that the external device transmits MIDI Clock data.
128
Does not respond to MIDI messages Make sure that all MIDI cables are connected correctly. 22
Make sure that the external device is transmitting through MIDI channels enabled to receive in the Liverpool. 47
79
Make sure that the MIDI IN Filters of the Liverpool do not prevent the reception of messages. 130
Percussive instruments are not
played correctly
Make sure that the Percussion and Drum Track is set to Drum Mode and the
external device has not transposition applied.
46
78
Some “clicks” can be heard when
playing a percussive instrument
This is part of the sound, and not a problem.
A background noise can be heard
after selecting a Performance, Style
or STS
The selected Performance, Style or STS recalled the effect “15 Analog Record”, simulating the noise of a old
vinyl recording.
Card related problems
Cannot format a card Is the card inserted correctly? 131
Cannot save data to a card Is the card formatted? 141
Is the card inserted correctly? 131
Cannot load data from a card Is the card inserted correctly? 131
Does the card contain data compatible with the Liverpool? 132

Table of Contents

Related product manuals