185
012: Sub Oscill
(Stereo Sub Oscillator)
This effect adds very low frequencies to the input sig-
nal. It is very useful when simulating a roaring drum
sound or emphasizing powerful low range. This effect
is different from the equalizer in that you can add very
low range harmonics. You can also adjust the oscillator
frequency to match a particular note number, for use as
an octaver.
a: OSC Mode, b: Note Interval, b: Note Fine
The “OSC Mode” parameter selects the oscillator operation
mode. When Note (Key Follow) is selected, the oscillator’s
frequency is determined based on the note number, allowing
you to use it as an octaver. The “Note Interval” parameter sets
the pitch offset from the original note number by semitone
steps. The “Note Fine” parameter allows you to fine-tune in
steps of cents.
d: Envelope Pre LPF
This parameter sets the upper limit of the frequency range to
which very low harmonics are added. Adjust this parameter if
you do not want to add lower harmonics to the higher range.
013: Talking Mod
(Talking Modulator)
This effect adds an unusual character, like a human
voice, to the input signal. Modulating the tone via
dynamic modulation, you can create an interesting
effect that sounds as if the guitar or synthesizer is talk-
ing.
c: Voice Top, d: Voice Center, e: Voice Bottom
These parameters assign vowels to the top, center, and bot-
tom position of the controller.
E.g.: When “Voice Top”=A, “Voice Center”=I, and “Voice Bot-
tom”=U:
If “Sweep Mode ”is set to D-mod and Ribbon is selected as
the modulation source, moving your finger from the right to
left of the ribbon controller will change the sound from “a” to
“i,” then “u.”
a
OSC Mode Note (Key Follow), Fixed
Determines whether the oscillator frequency follows the note number or
whether it is fixed →
b
Note Interval –48...0
Sets the pitch difference from the note number when OSC Mode=Note (Key
Follow) →
Note Fine
Fine adjustment of the oscillator frequency
–100...+100
→
c
Fixed Frequency [Hz] 10.0...80.0Hz
Sets the oscillator frequency when OSC Mode=Fixed
Src Off...Tempo
Selects the modulation source for the oscillator frequency when OSC
Mode=Fixed
Amt –80...+80Hz
Sets the oscillator frequency modulation amount when OSC Mode=Fixed
d
Envelope Pre LPF 1...100
Sets the upper limit of the frequency range for which very low harmonics are
added →
e
Envelope Sens (Envelope Sensitivity) 0...100
Sets the sensitivity with which very low harmonics are added
Envelope Shape
Sets the oscillator’s volume envelope curve
–100...+100
f
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 177
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 177
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 177
–100...+100
Wet / Dry
Note No.
OSC Mode
Fixed
Note (Key Follow)
Sine Oscillator
Fixed Frequency
Pitch
Note Interval, Fine
Stereo In - Stereo Out
Left
Right
Wet / Dry
Envelope Sens
Envelope Shape
Envelope Shape
D
-mod
Pre LPF
Envelope Sens
Pre LPF
a
Sweep Mode D-mod, LFO
Switches between modulation source control and LFO control
b
Manual Voice Control Bottom, 1...49, Center, 51...99, Top
Voice pattern control
Src Off...Tempo
Selects the modulation source that controls the voice pattern
c
Voice Top
Selects a vowel sound at the top end of control
A, I, U, E, O
→
d
Voice Center
Selects a vowel sound in the center of control
A, I, U, E, O
→
e
Voice Bottom A, I, U, E, O
Selects a vowel sound at the bottom end of control →
f
LFO Frequency [Hz] 0.02...20.00Hz
Sets the LFO speed →Fx:009,
Src
Selects the modulation source of LFO speed
Off...Tempo
Amt –20.00...+20.00Hz
Sets the modulation amount of LFO speed
g
BPM/MIDI Sync Off, On
Switches between using the frequency of the LFO speed and using the
tempo and notes →Fx:009,
BPM
Selects MIDI Clock and assigns tempo
MIDI, 40...240
→Fx:009
Base Note
Selects the type of notes that specify the LFO speed →Fx:009
Times x1...x16
Sets the number of notes that specify the LFO speed →Fx:009
h
Formant Shift –100...+100
Sets the frequency to which the effect is applied →
Resonance
Sets the Level of resonance of the voice pattern
0...100
→
i
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 177
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 177
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 177
–100...+100
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Right
Wet / Dry
Wet / Dry
+
D
-mod
Voice Top: A
Voice Center: I
Voice Bottom: U
A
-
I
-
U
-
E
-
O
Talking Modulator
LFO
D-mod
LFO
Sweep Mode
To Next Page
Loading...
