Audio recording Placing a WAVE file in an audio track
103
7. Press the OK button, the selected region will be placed
in the audio track.
8. Select the event that you want to edit, and use the
location parameters “Measure” and “Beat Tick” to
edit the location of the event.
You can’t place two or more events at the same location.
9. Press the Done button.
10.Press the SEQUENCER START/STOP button, and
make sure that the WAVE file plays back.
When the “Compare” page menu command is executed,
the audio track returns to the state prior to the edit you
just performed.
We’ve kept this example simple, but you can also perform
editing operations such as changing the playback position of
the WAVE file in steps of a single sample, changing the
location relative to an anchor point, or crossfading two audio
events. For more information, see “Audio Automation Edit”
on page 538 of the PG.
To Next Page
Loading...
