Global Settings, Wave Seq., Drum Kits
184
Programming Basics
The Wave Sequence parameters are spread over two pages.
The Seq Parameters page has controls for the Wave
Sequence as a whole, such as the start and end steps,
looping, and modulation.
The Step Parameters page goes deeper into the structure of
the Wave Sequence, allowing you to edit each of the 64
Steps.
Programs, Combinations, and Songs also have a handful of
Wave Sequence-related parameters, to make it easier to fit
Wave Sequences in with other sounds and rhythmic
components (such as ARP).
The Wave Sequence graphic, shown on both the Seq
Parameters and Step Parameters pages, gives you a quick
overview of the sequence, at a glance:
• The current step is marked by a white arrow.
• Red boxes are Multisample steps.
• Gray boxes are Tie steps.
• Black boxes are Rest steps.
• The length of the Wave Sequence, from the Start Step to
the End Step, is shown by a rectangular outline.
• The Loop is highlighted in blue.
• At the bottom right of the graphic is a Solo button. When
this is turned on, the Wave Sequence will play only the
current step, including its fade-in and fade-out.
•On the Step Parameters page, the bar at the top of the
graphic shows you the eight steps currently displayed on
the screen.
Wave Sequence graphic
To Next Page
Loading...
Need help?
General
