Kramer VIA GO2

Kramer Electronics Ltd.
VIA GO² – For Installer: Mounting VIA GO²
8
For Installer: Mounting VIA GO²
This section provides instructions for mounting VIA GO². Before installing, verify that the
environment is within the recommended range:
• Operation temperature – 0 to 40C (32 to 104F).
• Storage temperature – -40 to +70C (-40 to +158F).
• Humidity – 10% to 90%, RHL non-condensing.
Caution:
• Mount VIA GO² before connecting any cables or power.
• The device is intended to be installed at a height of 2 meters or less.
Warning:
• Ensure that the environment (e.g., maximum ambient temperature & air flow) is
compatible for the device.
• Avoid uneven mechanical loading.
• Appropriate consideration of equipment nameplate ratings should be used for avoiding
overloading of the circuits.
• Reliable earthing of rack-mounted equipment should be maintained.
You can install VIA GO² using one of the following methods:
▪ Place the device on a flat surface.
▪ Place the device on a flat surface.
▪ Mount on a wall or the back of a display using the included VESA mounting bracket:
1. Attach the VESA mounting bracket
to the back of the display with 4
screws.
2. Fasten two screws to the bottom
of
VIA GO².
3. Insert the screws on the
bottom of
VIA GO² into the slots on
the mounting bracket.
When mounting the device on a display, the installer MUST secure the display to prevent
instability.