VIA GO² – For Web Administrator: Configuring Settings – Gateway Management Pages
Pairing a VIA Pad Device
Each VIA Pad device must be paired to your VIA GO² unit before being used by a meeting
participant.
To pair a VIA Pad device to your VIA GO² unit, follow the directions below:
Site Management
VSM (VIA Site Management) is an optional, web-based software application (purchased
separately) that enables an administrator to monitor and make changes to all VIA gateways
connected to a network. VIA GO² enables you to activate VSM management for a VIA
gateway and define which gateway functions are managed by VSM.
Contact your regional sales representative for more details about this solution.
If VIA discovery is enabled and configured in VSM, your VIA device is automatically added
under VSM supervision.
To configure VIA GO² to be managed by VSM when VIA discovery is not activated:
1. Click Device Management > Site Management on the navigation pane.
The VIA Site Management page appears.
Figure 18: VIA Site Management Page
To Next Page
Loading...
Need help?
General