XII - 8
Special Equipment
Hydraulic hose connections
Connect the pressure connection to a single-action
control device. Connect the reverse flow to a pressure-
free reverse-flow connection.
A hydraulic connection with continuous oil supply and
non-pressurised reverse-flow is required on the tractor.
The amount of oil must not exceed 20 litres per
minute.
Lubrication points
All repair, maintenance, servicing and
adjustment work may only be carred
out when the machine is at a stand-
still. Switch off the engine and remove
the ignition key. Engage the flywheel
brake.
50h
BP380-7-123
Lateral limitation
• Lift the swath distributor (1) from below to the
drawbar (3)
• Place swath distributor with screws (2) on drawbar
(3)
• Line up the swath distributor in the centre in front of
the pick-up
• Tighten the screws
• Install the protective plate above the drive
Installing swath distributor
• Push in the lateral limiter (4) on both sides with the
support (3) in the rectangular pipe (1)
• Adjust the range of the pick-up width and undo the
screws (2)
• Set the lateral limiter according to the pick-up width
• Tighten the screws
1
2
3
2
BP380-7-121
BP380-7-122
43
2
1
To Next Page
Loading...
