VII - 8
Care and Maintenance
7.8.3 Brake Cylinders
Excess pressure should be released from the compressed air system before disassembling the
membrane brake cylinder.
There is a danger of injury!
Special maintenance for the brake cylinders (1) is not
necessary. The membrane cylinders should be
removed, disassembled, cleaned, parts subject to wear
replaced and reassembled at least every two years.
The guide rollers (1) on the feed rake drum (2) are
subject to heavy use. Undo the nuts (3) to replace the
guide rollers. Pull the guide rollers out of the hole in the
side wall of the rake housing.
Insert new guide rollers and secure with the nuts.
Torque moment:
Large guide rollers: NukR 72 (M24 x 1,5) = 250 Nm
Small guide rollers: NukR 40 (M18 x 1,5) = 120 Nm
7.9 Replacing the Guide Rollers on the Rakes
BP380-7-085
1
BP380-7-086
2
31
To Next Page
Loading...
