Krone Big Pack 127 / MultiCut - Alarm Messages; Blade Check on the Cutting Mechanism (Special Equipment)

IV - 9
Comfort Controls
4.6.6 Blade Check on the Cutting Mechanism (Special Equipment)
off-.blade contr. on
....... off !.......
or
off-.blade contr. on
....... on !........
You can switch from "ON" to "OFF" by pressing button
or by switching button from "OFF" to "ON".
You can return to the programme by pressing button
1
.
A flashing indicator light on button (8) indicates that the
tension bolt in the blade safety mechanism is faulty.
- Alarm-No.:....0000
Tensioner faulty!!..
4.6.5 Alarm Messages
Alarm messages appear in the display when irregulari-
ties are picked up by the on-board computer. Alarm
messages always take preference. They interrupt the
current display immediately.
A horn sounds in the control box at the same time as
the alarm message appears. The horn can be switched
off using button
3
. If button
3
is pressed
again, the alarm message in the display disappears and
the previously shown message reappears. Some faults,
e.g. "BALING THRUST EXCEEDED", correct themsel-
ves.
Übersicht der Alarmmeldungen siehe Anhang A 1.4
Alarm- und Fehlermeldungen bei der Big Pack 88 /
127 / 128.
4.7 Sonstiges
Depending on the operating status, the following messages
appear in the display when button
8
is pressed:
Hinweis zur Fehlersuche, zu Tests und
speziellen Einstellungen entnehmen Sie
bitte dem Anhang A1!
Prog Quit
#
12 90
34
BP-VFS-079
- Alarm-Nr.:....0000
Fadenspanner defekt!
13
5 6
87
P max
Prog Quit
#
12 890
34
BP-VFS-080
aus Messerkontr. ein
....... aus !.......
5 6
87
Pmax
8