XII - 6
Special Equipment
BP-VFS-034
21
3
4
2
If the big pack baler is fitted with hydraulic brakes, the
compressed air for cleaning the knotter is supplied via a
compressor (1) mounted between the hitch supports. It
is driven by a V-belt disk (3) and V-belt (2) mounted on
the flywheel. The tension of the V-belt can be adjusted
by shifting the compressor in the slots (5).
The oil level must be checked at the dipstick (4) every
day before use. Top up with oil (engine oil SAE 20) if
necessary. The specifications for the oil required are
listed in the section "Technical Data".
12.2 Compressor
The air inlet filter (6) should be cleaned
at least once a day and in case of heavy
dust loads several times a day.
• Move the retaining clip (2) on the air filter (1) up/
down
• Remove cover (4)
• Dismount filter cartridge (3), tap it and with blow
through from the inside outwards with air jet
• Dismount cover (4) again and tap it
• Install filter cartridge
• Put cover on filter and secure with retainng clips
Make sure that the filter pot with the air
filter locks tightly. Dabei die Markierung
"oben" beachten!
Filter cleaning
• Let the control lever (2) engage in position B
• Turn back flywheel until the blockage is removed.
When you start up the machine again the free-wheel
switches on automatically. The control lever (2) goes
back into basic position A.
BP380-7-117
2
BP-VFS-033
1 4
2
3
6
5
To Next Page
Loading...
