Krone Big Pack 127 / MultiCut - 1 General; Designated Purpose; Technical Data

I - 1
General Information
1.2.4 Identification
The machine data are listed on the identification plate
(1). This is located on the right inner side of the
machine under the angle gear.
1.2.5 Data Required for
Inquiries and Orders
When making inquiries concerning the machine or
ordering replacement parts, be sure to provide type
designation, vehicle ID number and year of manu-
facture.
Genuine replacement parts and
accessories authorized by the
manufacturer help ensure safety.
Use of other parts may void liability
for damage which results.
The entire identification plate re-
presents a legal document and should
not be altered or rendered illegible!
Type
Year
Vehicle
ID no.
1 General Information
The operating manual contains basic instructions to be
observed when attaching, operating and doing
maintance work. Therefore it is imperative that the
operating personnel have access to and read this
operating manual before putting into operation and
using the implement.
Follow both the general safety instructions contained in
the section on safety and the specific safety
instructions contained in the other sections.
1.1 Designated Purpose
The big square balers Big Pack 88 / MultiCut, Big Pack
127 / MultiCut and Big Pack 128 / MultiCut are pick-up
balers mit dem "Variablen Füll-System". They produce
highly compressed and consistent big square bales
with a length from 1.0 to 2.5 m and 1.2 or 0.8 m width.
The big square balers are fitted as standard with a
tying unit and a two-part bale chute.
1.2 Technical Data
1.2.1 General Information
This operating manual is valid for the Big Baler Big
Pack 88 /MultiCut, Big Pack127 /MultiCut and Big
Pack 128 /MultiCut from machine-no. 490 000
1.2.2 Manufacturer's Address
Maschinenfabrik Bernard Krone GmbH
Heinrich-Krone-Straße 10
D-48480 Spelle (Germany)
Telephone: (49) 0 59 77/935-0
Fax: (49) 0 59 77/935-339
E-mail: info.ldm@krone.de
1.2.3 Certification
Declaration of Conformity (requirements of the EC
Machine Directive 89/392/EEC; 3. amending directive
of 22.7.93 has been fulfilled.)
See reverse side of title page
Maschinenfabrik Bernard Krone GmbH
Heinrich-Krone-Str. 10 D-48480 Spelle
Made in
Germany