VI - 14
Settings
6.13 Basic adjustment of the flywheel
brake
The flywheel brake must be re-adjusted if the brake
power is no longer satisfactory (worn brake block) or if
the flywheel brake has been removed (e.g. after
replacement of the friction clutch).
For this proceed as follows:
1. Remove pin (1) from the brake lever and remove the
brake lever (this step is best with the flywheel brake
pulled).
2. Release bolts (2) and remove the protective cover.
3. Install the brake lever.
4. Release the brake.
5. Check dimension „A“: this should be equal to 200
mm. Adjust as necessary using nut (3).
6. Pull the brake.
7. Check dimension „B“: this should be equal to 28
mm. To correct dimension „B“ release the brake
again and adjust the grub screws (4) at either side of
the brake saddle. This will move the brake blocks
closer to the brake disc. Pull the brake again and
check dimension „B“.
The distance between brake saddle (5)
and rods (6) must be equal at either side
of the brake saddle. Correct by adjusting
the bolts (4) as required.
BP380-7-165
1
2
4
BP380-7-166
3
B
A
B
5
6
BP380-7-168
To Next Page
Loading...
