Krone Big Pack 127 / MultiCut - Safety; 2.1 Identifying Safety Instructions in the Operating Manual; 2.2 Safety Instructions and Accident Prevention Regulations; Preparing the Big Pack Baler

1
List of contents
List of Contents
1 General
1.1 Designated Purpose ........................................................................................................... I - 1
1.2 Technical Data .................................................................................................................... I - 1
2 Saftey
2.1 Identifying Safety Instructions in the Operating Manual .................................................... II - 1
2.2 Safety Instructions and Accident Prevention Regulations ................................................. II - 1
2.3 Introduction ........................................................................................................................ II - 6
2.4 Overview of the Big Pack Baler with Individual Axle (Left Side) ........................................ II - 8
2.5 Overview of Big Pack Baler with Tandem Axle (Right Side) .............................................. II - 9
2.6 The BIG PACK Baler Working Method .............................................................................. II-10
3 Preparing the Big Pack Baler
3.1 Special Notes on Safety ................................................................................................... III - 1
3.2 Adjusting the Height of the Swinging Drawbar ................................................................. III - 1
3.3 Adapting the Main PTO Shaft ........................................................................................... III - 2
3.4 Putting the Big Pack Baler into Operation ........................................................................ III - 4
4 Comfort Controls
4.1 Special Notes on Safety ................................................................................................... IV - 1
4.2 General Description .......................................................................................................... IV - 1
4.3 Comfort Control Functions ................................................................................................ IV - 3
4.3.1 Adjusting the Bale Density ................................................................................................ IV - 3
4.3.2 Open Bale Channel .......................................................................................................... IV - 6
4.3.3 Bale Counter..................................................................................................................... IV - 6
4.3.4 Information........................................................................................................................ IV - 7
4.3.5 Alarm Messages ............................................................................................................... IV - 7
4.3.6 Blade Check on the Cutting Mechanism (Special Equipment) ......................................... IV - 8
4.3.7 Checking Sensors............................................................................................................. IV - 8
4.3.8 Language Setting ..............................................................................................................IV-11
4.4 Checking the Valves ......................................................................................................... IV-12
5 Working with the Big Pack Baler
5.1 Special Notes on Safety .................................................................................................... V - 1
5.2 Basic Setup for the Big Pack Baler .................................................................................... V - 1
5.3 Adjusting the Length of the Big Packs ............................................................................... V - 4
5.4 Twine ................................................................................................................................. V - 4
5.5 Emptying the Bale Channel ............................................................................................... V - 9
6 Settings
6.1 Special Notes on Safety ................................................................................................. VI - 1
6.2 Adjusting the Needles ..................................................................................................... VI -1
6.3 Twine Bar ........................................................................................................................ VI - 3
6.4 Baling Ram Setting ......................................................................................................... VI - 5
6.5 Guide Rail Cleaning ........................................................................................................ VI - 5
6.6 Setting the Rake Relative to the Baling Ram.................................................................. VI - 6
6.7 Adjusting the Sensors ..................................................................................................... VI -6
6.8 Adjusting the Flywheel Cleaning Mechanism ................................................................. VI - 7
6.9 Adjusting the Twine Brake .............................................................................................. VI - 8