VI - 8
Settings
Dismount the protective plate from the bracket (6) on
the left hand side of the machine. Remove the roller
chain (5) from the rake gearbox (7) drive shaft. Move
the piston rods into the exrended position (rear dead
centre). The rake (fixed into position with the mounting
lever) and the ram are now in position for the adjust-
ment. Place the chain coupling roller chain (5) in po-
sition and secure. Attach protective plate and remove
the mounting lever.
Turn the machine manually through one entire revo-
lution at the flywheel.
6.6 Setting the Rake Relative to the Baling
Ram
The rake must be adjusted when rake
gearbox or the chain coupling connect-
ion chains are replaced.
Turn the rake manually in the working direction until the
small guide roller (3) des Zubringers (1) is visible in
window (2) on the right hand side of the machine. Lift
up the guide roller with a mounting lever (4) so far that it
meets resistance. Hiermit wird sichergestellt, daß das
Raffergetriebe eingerastet ist.
Danach wird der Raffer soweit vorgedreht, bis die
Rafferleiste (8), die der Zubringerleiste (9) vorauseilt,
mit der Einstellmarke (10) übereinstimmt. In dieser
Position den Raffer mit einem Montierhebel festsetzen.
BP380-7-064
1
2
3
4
BP380-7-065
3
2
1
BP-VFS-095
To Next Page
Loading...
