VI - 15
Settings
6.14 Installing the flywheel brake
The flywheel brake must be removed for any
replacement of the friction clutch.
Utmost care is essential during the subsequent
installation of the brake.
Installation procedure:
1. Install the intermediate PTO shaft onto the friction
clutch.
2. Install the guard of the intermediate PTO shaft.
3. Slide cross bracket (1) with bearing housing,
grooved ball bearing and eccentric ring onto the
intermediate PTO shaft. The bearing must face the
rear side.
4. Slide brake disc (2) with the profiled hub onto the
intermediate PTO shaft. The profiled hub must face
the rear side.
5. Install housing (3) onto the drawbar. Note that the
front coach bolts (4) must be inserted from outside
to prevent damage to the tractor tyre. The rear
coach bolts (5) must be inserted from inside. Do not
yet tighten the bolts.
6. Install the cross member hand tight onto the
housing. The bolts (6) must be inserted from
outside.
7. Align housing (3) at a right angle to the intermediate
shaft. The inner dimension of the housing is A = 300
mm. The distance between drawbar and housing
can be corrected using shims. Tighten the bolts (4)
and (5) firmly.
8. The distance between the brake discs and the cross
member must be B = 26 mm over the entire length.
Only when this distance is set to the correct
dimension, the bolts of the cross member can be
tightened. Attention: This dimension must be
adjusteed as accurately as possible. Work with
utmost care!
9. Tighten the bolts inside the profiled hub.
10.Bolt on the brake saddle.
11.Install the brake rods.
12.Adjust the brake rods in accordance with the
description of section 6.10.
13.Check once more that the brake disc does not come
into contact with the brake saddle.
BP380-7-169
1
2
B
BP380-7-170
A
BP380-7-167-1
4
5
3
To Next Page
Loading...
