Krone Big Pack 127 / MultiCut - 7 Care and Maintenance; General

VII - 1
Care and Maintenance
7. Care and Maintenance
7.1 Special Notes on Safety
• Repair, care, maintenance and cleaning work may only be carried out with the machine at a
standstill. Switch off the engine and remove the ignition key. Apply the flywheel brake.
• Secure the big pack baler and the tractor from rolling away.
• After completion of care and maintenance work replace all protective plates and protective
devices properly.
• Avoid skin contact with oils and greases.
• High pressure hydraulic fluids can cause severe injuries. In case of injury seek immediate
medical attention. Risk of infection.
• Follow all other notes on safety to prevent injury and accidents.
To guarantee perfect operation of the big pack baler and to reduce wear, maintenance and care
work must be carried out at certain intervals. This includes amongst other things cleaning,
greasing, lubricating and oiling of parts and components.
7.2 General
Torque moment M
A
(if not otherwise specified).
A = thread size
(Screw class visible on screw head.)
Check regularly (approx. every 50 hours) that nuts and screws are firmly tightened and tighten
up if necessary!
8
.
8
1
0
.
9
A
BP380-7-073
A
5.6
29
42
2,2
4,5
7,6
18
37
64
100
160
4,4
8,7
15
36
72
125
200
215
310
1050
330
350
M 4
M 5
M 6
M 8
M 10
M 12
M 14
M 14x1,5
M 16
M 16x1,5
M 20
M 24
6.8
M (Nm)
8.8 10.9
A
O
/
12.9
M 24x1,5
M 24x2
M 27
M 27x2
M 30
5,1
10
18
43
84
145
235
255
365
2450
390
3,0
5,9
10
25
49
85
135
145
210
225
730
710
1220
1350
1800
1950
2100
1150
1550
1650
1450
800
1100
1150
610
425