A - 1
Appendix
A1 Integrated Diagnostic Program – Comfort Controls
A1.1 General Information
The integrated diagnostic program is an integral part of
the comfort controls.
The diagnostic program enables you to check the electri-
cally and electronically operated components on the big
baler and their power supply. You can also modify the
factory-preset basic settings.
This technical documentation describes the technical
data of the time when it was drawn up. Subject to tech-
nical alterations. When allocating the plug and cable
designations please always observe the current
indication in the comfort control display.
If errors should occur in the processing
sequence, always check whether there
have been any operating errors first.
Observe the operating manual!
If it is possible to localize an error on the
machine and if according to visual exami-
nation the error correction does not seem
easy, please contact your service partner!
Do not carry out any technical modifica-
tions on the machine. This may cause
damage to the machine or safety equip-
ment!
To Next Page
Loading...
