III - 5
Preparing the Big Pack Baler
Pick Up Drive
The drive for the pick up is located on the right hand
side of the machine. The torque is transmitted by a
bevel gear arrangement (1) downwards through a PTO
shaft (2) with an overload protection mechanism (over-
run clutch) to an angular gear (3).
3.4.2 Attaching the Big Pack Baler to the Tractor
Hitching
Attach and secure the big pack baler to the tractor
hitching mechanism as specified.
Je nach landesspezifischen Anforderungen stehen eine
drehbare Zugöse oder eine Hitch-Anhängung zur
Verfügung (see ch. 12.6).
Spacer Bush for the Swinging Drawbar with Bottom Attachment
Swinging drawbars often have a retaining bolt with a
diameter smaller than for the hitch. For this reason a
spacer bush (2) is supplied along with big pack balers
with bottom attachment, which can be used with the
tractor hitch (1) when required.
• Nobody may be between the tractor and the baler when reversing the tractor up to the big
pack baler.
• Observe the maximum supported and towed loads for the hitching mechanism on the
tractor.
BP380-7-012
1
2
3
BP380-7-013
BP380-7-014
2
1
To Next Page
Loading...
