V - 3
Working with the Big Pack Baler
5.2.2 Pack Chute
When folded out the pack chute is an extension of the
bale channel. The pack chute must be at the same level
as the bale channel so that the packs can be deposited
properly.
An adjustment can be made using the nuts (1) and (4)
on each side of the bale channel. This adjusts the
length of the retaining chain (3) for the front section of
the pack chute and the retaining chain (2) for the rear
section.
5.2.3 Regulation of the Baling Thrust
The baling thrust in the bale channel is regulated by an
electronic-hydraulic system. The baling thrust is adju-
sted on the comfort control. The current pressure in the
baling hydraulics can be read off the pressure gauge (1)
on the front right hand side at any time.
There is another pressure gauge (2) located on the right
hand side of the machine near the knotter board beside
the hydraulic control block (1).
BP380-7-038
3
2
1
4
To Next Page
Loading...
