XII - 2
Special Equipment
BP-VFS-031
The blade control shaft must be
secured using the locking lever once
the setting has been made.
Setting the cutting length
Turn the locking lever (3) to the right.
(selector disc unlocked.)
Fit the special spanner (1) onto the blade control
shaft (2) and turn it in the direction of the arrow.
Turn the blade control shaft (2) to the desired position
using the special spanner (1). (Here 45 mm cutting
length)
The locking lever (3) must be turned to the left until it
clicks in.
The outer blades must be removed the
outer edges of the bales become
unstable.
BP380-7-105
To Next Page
Loading...
