Krone Swadro 1010 - Adjusting the Direction of Travel; Adjusting the Track; Travel Speed and Drive R.p.M

V - 4
Basic setting
5.4 Adjusting the Direction of
Travel
The direction of travel of the rear running gear can be
adjusted by adjusting the suspension arm (1).
• Loosen counter-nut (2).
• Adjust suspension arm.
Shorter suspension arm
=> Adjusts the machine further to the left
Longer suspension arm
=> Adjusts the machine further to the right
• Tighten counter-nut (2).
5.5 Travel speed and drive r.p.m.
The travel speed and drive r.p.m. are determined by:
• the feed volume
• the ground conditions
• the dryness
The following should be taken as starting points:
• PTO shaft speed approx. 450 r.p.m.
• Forward speed approx. 8- 10 km/h
Drive r.p.m. and forward speed should be adapted to the
particular conditions each time.
SW101026
1
2
SW101035
3
2
2
5.4.1 Adjusting the track
The track control arms (3) can be used to control on the
track on the running wheels.
• Loosen counter-nut (2).
• Adjust suspension arm.
• Tighten counter-nut (2).