EasyManua.ls Logo

Krups Nescafe Dolce Gusto Lumio KP130110 - Page 32

Krups Nescafe Dolce Gusto Lumio KP130110
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Lumio service manual
32
TROUBLESHOOTING
9 Prepare a
beverage
p. 24
9.1 Hot water temperature is
- too low (less than 70°C /
158 °F) or
- too high (more than
95°C / 203 °F)?
(Set up for temperature
measurement p. 72)
YES - a) Fluid system scaled?
YES - Descale fluid system
( p. 89)
NO - Go to point b)
YES - b) NTC temperature
sensor (32) defective?
YES - Replace NTC
temperature sensor
p. 49
NO - Go to point c)
YES - c) Flow rate of pump out
of range?
YES - Replace pump (19)
( p. 45)
NO - Go to point d
YES - d) Valve malfunction?
YES - Replace cpl. coffee
machine
NO - Go to point 9.2
9.2 Cold water temperature
at outlet is too high compared
with water tank temperature?
YES - Valve malfunction?
NO - Go to point 10
YES - Replace cpl. coffee
machine
10 Check for leaks
and/or flow rate
while preparing a
beverage (
p. 76
)
10.1 Leakage at extraction
head?
YES - a) Capsule holder (3)
leaking?
YES - Replace capsule
holder
NO - Go to point b)
YES - b) Pressure hoses
damaged or leaking at connec-
tions?
YES - Replace cpl. coffee
machine
NO - Go to point 10.2
10.2 Water underneath
coffee machine?
YES - a) Pressure hoses, water
tank connector tube or silicone
elbow leaking?
NO - Go to point 10.3
YES - Replace leaking
tubes or pressure hoses
with clips (26).
NO - Go to point b)
YES - b) Pump outlet leaking?
YES - Check pump outlet
and O-ring, re-assemble
with correct torque (
p. 36
).
Replace pump (19) if
necessary ( p. 45).
NO - Go to point 10.3
10.3 Flow rate out of range?
(Set up for flow rate meas-
urement p. 72)
YES - a) Fluid system scaled?
YES - Descale fluid system
( p. 89)
NO - Go to point b)
YES - b) Injector in capsule
holder scaled or blocked?
YES - Deblock injector with
cleaning needle p. 88
and descale again
p. 89
NO - Go to point c)
YES - c) Water tank valve dirty
or defective?
YES - Clean water tank
valve or replace water tank
NO - Go to point d)
YES - d) Filter in water tank
connector blocked?
YES - Clean or replace
water tank connector (20)
( p. 55)
NO - Replace pump (19)
( p. 45)
Check
procedure
Symptoms Action / repair work
Further action /
repair work

Table of Contents

Related product manuals