Lumio service manual
82
FINAL INSPECTIONS
FINAL INSPECTIONS
General
Legal situation
Repair centres can be legally obligated to ensure the safety and physical integrity of the
user/consumer by national regulations and standards.
The basic demands of these regulations are:
• The regular condition of the coffee machine has to be restored after a repair.
• If covers or housing parts of the coffee machine were removed during a repair,
certain tests like shown in this chapter have to be performed after final assembly.
Test equipment
The necessary test equipment
- has to be obtained by the repair centre,
- must comply with EN/IEC 60335-1 and national standard(s) for after-repair testing
(e.g. DIN VDE 0701),
- has to be calibrated by a qualified test centre periodically.
Ideally the test equipment has a national power socket for testing, so that the coffee
machine can plugged in directly. Otherwise a special shunt is necessary to connect the
phase and neutral pin of the coffee machine’s power plug.
Test procedures
The after-repair tests shown in this chapter
- are based on the German standard DIN VDE 0701 - 0702,
- are valid therefore for German repair centres only,
- are explained only generally and serve as an example for other nationalities.
For detailed information refer to the operating manual of your test equipment and your
national standard(s) for after-repair test.
Job-related requirements for after-repair testing
After-repair tests should only be performed by a certified electrician
- with experience in electrical metrology,
- who is familiar with the test equipment and the applicable national standard(s).
Test report
The repair centre should prepare a test report for each repaired coffee machine and
keep it safely.
Check the legal sit-
uation in your coun-
try
to avoid prosecution.
Contact the sales
partner in your
local region as per the
Instruction book and
warranty card.
Only symbolic illustrations of test equipment are shown in this manual.
To Next Page
Loading...
