Lumio service manual
55
REPAIR
Replace water tank connector with filter
Prerequisites:
• The flow meter (22) is removed p. 42.
• The building block (15) is removed from the component frame (8) p. 50.
• Housing right (4) and housing left (5) are removed p. 59.
• The 2 screws that hold together component frame (8) and support frame (6) are
removed p. 66.
Procedure:
1. Loosen 2 screws (TX10 with safety pin).
2. Release latch and remove component frame (8) from main frame (7).
3. Remove water tank connector (20).
4. Pull filter (25) out of water tank connector with pointed pliers.
To Next Page
Loading...
