6 Operation
29 of 88
BoosterControl Advanced
All parameter settings can be saved/loaded.
1. To save the active set of parameters, select parameter 3-2-2-4.
2. To load a saved set of parameters, select parameter 3-2-2-3.
ð BoosterControl Advanced reboots.
6.4.3 Saving/loading factory settings
Possible from customer access level (load only), possible from factory access level
(load and save).
All parameter settings can be saved/loaded.
1. To save the active set of parameters, select parameter 3-2-2-5.
2. To load a saved set of parameters, select parameter 3-2-2-1.
ð BoosterControl Advanced reboots.
6.4.4 Resetting to default settings
Only possible from service access level.
All default parameter settings can be loaded.
1. To load this parameter set, in the selection window, after selecting parameter
3-2-2-6, select the correct target configuration.
ð BoosterControl Advanced reboots.
6.4.5 Enabling/disabling the password
When the password has been disabled, BoosterControl Advanced always boots at
customer access level.
ü The user has logged in.
1. Select parameter 3-2-1-2.
2. To enable the password:
Select "Yes".
3. To disable the password:
Select "No".
4. Press "OK" to confirm.
6.4.6 Displaying general information
The following parameters can be used to display general information about
BoosterControl Advanced:
Parameter description
Table22: Displaying general information
Parameter Description
4-1-1 Serial number of control module
4-1-2
2)
Parameter set of control module (XML)
4-2-2 Firmware version of control module (I/O)
4-2-3 Firmware version of control module (I/O)
4-3-2 Firmware version of control module (HMI)
4-3-3 Firmware version of control module (HMI)
4-4-1 Firmware version of Profibus (if available)
4-4-2 Firmware version of Profibus (if available)
4-5-1 Firmware version of Modbus (if available)
4-5-2 Firmware version of Modbus (if available)
2) Displayed at factory access level only.
To Next Page
Loading...
